Comparisons
Repair or replace your well pump?
The first question is not repair or replace. It is what actually failed. Many no-water calls turn out to be surface parts.
This is a referral line. When you call, you are connected with an independent local well pump company.
Test first
A company can test the pressure switch, control parts, wiring and motor from the surface. Ask what they tested and what the results were before agreeing to pull a pump.
When repair makes sense
Switches, control box parts, a waterlogged tank, a clogged filter or a leak in accessible pipe are usually repairs. The pump stays in the well.
When replacement is likely
A failed submersible motor or pump end usually means a new pump, because they are sealed units. Age, past repairs and worn performance all factor in.
Deep wells change the math
Because pulling a deep pump is real work, many owners replace related parts while it is out. With local median depths from 265 ft to over 500 ft,[source] ask what else the company recommends replacing and why.
Getting a second opinion
For a major job, it is reasonable to ask a second company to look. Ask each one to explain what they tested and what they found. If both find the same failure, you can decide with confidence. Always ask for the Arizona ROC license number and check it.[source]
Questions
How old is too old for a pump?
There is no single age. Ask the company what they see.
Can a used pump be reinstalled?
Ask the company. Most install new.
Should I get a second opinion?
On big jobs, many owners do. That is your call.
Related help
Want to talk it through?
Call and get connected with a local well pump company.
Call about your well(928) 655-8940